Life-Stress Data Folio
For life-stress data only.
In basic life data analysis, units are tested under normal use conditions in order to obtain information about a product’s failure behavior. In some cases, however, it is desirable to obtain this information more quickly than is possible with use level testing. For example, products with long lifetimes or short periods between design and release, as well as products that are operated continuously, may produce results too slowly with basic life data analysis.
The Accelerated Life Testing (ALTA) life-stress data folio is used to perform quantitative accelerated life testing data analysis. In this analysis, the engineer extrapolates a product’s failure behavior at normal conditions from life data obtained at accelerated stress levels. Since products fail more quickly at accelerated stress levels, this sort of analysis allows the engineer to obtain reliability information about a product (e.g., mean life, probability of failure at a specific time, etc.) in a shorter time. The ReliaWiki resource portal has more information on the basics of accelerated life testing at: http://www.reliawiki.org/index.php/Introduction_to_Accelerated_Life_Testing.
Note: Life-stress data folios are available only if supported by your license. For more information, contact us.
- Life-Stress Data Folio Setup and Accelerated Life Testing Data Types
- Life-Stress Data Folio Control Panel
- Accelerated Life Testing Plots
- Accelerated Life Testing Calculations
- Example: Single-Stress Accelerated Life Testing Data Analysis
- Example: Two-Stress Accelerated Life Testing Data Analysis
- Time-Dependent Stress Profiles
- Example: Accelerated Life Testing with Stress Profiles
Tools
- Distribution Wizard (choosing a distribution to fit the data)
- Likelihood Ratio Test
- Add or Remove Stress Columns
- Convert Stress Values
- Calculations with Insufficient Test Data
- Transfer Data to a Life Data Folio
